QuickSeam Products
Discover our range of EPDM field-seaming products that are easy to use and show long-term performance below.
Discover our range of EPDM field-seaming products that are easy to use and show long-term performance below.
QuickPrime Plus is a high solids primer designed to clean and prepare the RubberGard EPDM membrane and/or substrate prior to application of QuickSeam products, Pourable Sealer or Lap Sealant. It must be applied with a QuickScrubber or QuickScrubber Plus pad and handle.
QuickSeam Splice Tape is a EPDM/butyl-based, self-adhesive tape designed for field splicing of Firestone RubberGard EPDM membrane panels. It is fully cured and provides consistent adhesive thickness within the seam.
QuickSeam Reinforced Perimeter Fastening Strip is a strip of reinforced EPDM membrane with a QuickSeam tape strip factory laminated to it along one edge. The strip is used to execute non-penetrating base tie-in details.
QuickSeam RMA Strip is a strip of reinforced EPDM membrane with a QuickSeam tape strip factory laminated to it along both edges. The strip is used for non-penetrating RubberGard EPDM membrane attachment in Firestone RMA Systems.
The Firestone QuickSeam Batten Cover Strip is a 152 mm (6") wide, semi-cured EPDM strip laminated to a QuickSeam tape. The strip is used to cover and seal Batten Strips, as specified in the Firestone Mechanically Attached System (MAS).
Firestone QuickSeam FormFlash consists of a 152 mm (6"), 229 mm (9"), 305 mm (12") or 450 mm (18") uncured EPDM strip factory-laminated to QuickSeam Tape. The strip is designed to flash inside and outside corners, pipes, penetrations and other applications as specified in the Firestone specifications and details.
Firestone QuickSeam SA Flashing is a 457 mm (18") wide, 1.52 mm thick non-reinforced RubberGard EPDM membrane, fully laminated to Firestone QuickSeam Tape. The SA Flashing can be used to easily flash details where cured EPDM is required or preferred: curbs, parapets, gutters, general roof repairs, drain and pipe flanges.
QuickSeam Flashing is a 127 mm (5") wide uncured EPDM strip laminated onto a QuickSeam tape. The strip is designed to flash metal roof edging profiles.
QuickSeam Pipe Flashing is a 'one size fits all' preformed EPDM pipe boot used for flashing of round, accessible penetrations of 25 mm to 150 mm.
QuickSeam Conduit Flashing is a 'one size fits all' preformed EPDM pipe boot used for flashing of round, accessible penetrations of 13 mm to 64 mm.
The Penetration Pocket Kit is specifically designed to be used around small pipe penetrations, clusters of pipes, l-beams, etc.
QuickSeam Walkway Pads are high-quality rubber pads with QuickSeam Tape factory laminated to the bottom and used for protection of RubberGard EPDM membranes in areas of regular traffic.
Ikaroslaan 75
1930 Zaventem, Belgium